RPR test shows up stragely when sent to state labs

Hi Bill, If you go under PH - SystemUtils - Lab Maintenance - Lab Setup - Query the Lab Type RPR and you will see the lab setup ( This particular one was set up per State Lab Interface requirements ) But you can change it for now and then just make the adjustments back to this when the interface is ready if you want to. You can see at the bottom of the screen there are 4 analytes attached to this Lab Test type, You can choose to expire and leave only one by clicking "CodeUpd" and entering an Expiration Date in all that you no longer want to see pulled into the patients record. The RPR is the last of the 4 analytes and you can click the View button to see them all. Thanks, Ranee

 I found this article helpful. (0)

 

Leave a Response